80
66 SettingsSettings
Date/Time Settings
Sets the date and time for the balance.
1. Call out the System settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [
System settings], and then press [ OK].
(3) Select [System settings] (Level 2), and then press [ OK].
2. Set the date and time
(1) Select [Date] or [Time], and then press [ OK].
(2) Enter the date or time, and then press [ OK].
^[Entering Numerals and Characters] (P.43)
Date and Time Settings
There are cases in which the administrator’s
password is required when amending date and time
settings to prevent tampering. Change the date
and time settings after the administrator has been
approved (password entered).
3. Return to the weight measurement mode
Press [ POWER].
Output Style Settings
Sets the date format for output to printer, etc.
1. Call out the System settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [
System settings], and then press [ OK].
(3) Select [System settings], and then press [ OK].
2. Set the output style for the date
(1) Select [Date Output Style], and then press
[ OK].
(2) Select either [YY/MM/DD], [MM/DD/YY] or
[DD/MM/YY], and then press [ OK].
Date Style Setting
The administrator’s password may be required to
change the setting for date output style in order to
prevent tampering. Change the date style setting
after the administrator has been approved (password
entered).
3. Return to the weight measurement mode
Press [ POWER].
*
*
To Next Page
Loading...
Need help?
General
