74
66 SettingsSettings
User Management (User Name Changes, Function Restrictions, etc.)
It is possible for the administrator to manage the balance when the log-in function is set at ON by
setting up to a maximum of ten users and then assigning authority to each of the functions they can
use. Only an administrator with an administrator’s password can use the user management function.
1. Call out the user settings
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [
System settings], and then press [ OK].
(3) Select [User Settings], and then press [ OK].
2. Select the user to set
Select [USER 01 - 10] (or the user name), and then
press [ OK].
Changing the Administrator Name and Password
To change the administrator’s user name and
password, select [Administrator] and then perform
Steps 4 and 5.
3. Validate or invalidate a user ID
(1) Select [User ID], and then press [ OK].
(2) Select [Valid] or [Invalid], and then press [ OK].
· Proceed to Step 4 if [Validate] was selected.
· Proceed to Step 7 if [Invalidate] was selected.
4. Change the user name
(1) Select [User Name], and then press [ OK].
(2) Enter the user name, and then press [ OK].
^ [Entering Numerals and Characters] (P.43)
*
To Next Page
Loading...
Need help?
General
