Shimadzu AP W-AD Series - X84; Amending the Zero and Tare Timing Function

59
1
3
5
2
4
6
7
8
12
14
13
9
10
11
66 SettingsSettings
2. Call out the Zero tracking function
(1) Press [ MENU] when the weight is displayed, and then press [ LEFT].
(2) Select [ Measurement Setting] and then press [ OK].
3.
Set the Zero tracking function to ON
or OFF
(1) Select [Zero tracking], and then press [ OK].
(2) Select [on] or [off] for the function, and then press
[ OK].
4. Return to the weight measurement mode
Press [ POWER].

Amending the Zero and Tare Timing Function
It is possible to select whether execute the zero/taring function without waiting for (stability mark)
to be illuminated (immediately), or to execute it after (stability mark) has been illuminated (at
stability) by pressing [ O/T] for Zero Point Setting/Taring with the zero/tare timing function.
The default is set at executing the function without waiting for (stability mark) to be illuminated.
1. Call out the measurement setting menu
(1) Press [ MENU] while in the weight measurement mode, and then press [ LEFT].
(2) Select [ Measurement Settings], and then press [ OK].
2. Set the zero/tare timing function
(1) Select [Zero/tare timing], and then press [ OK].
(2) Select [Immediate] or [Stabilized], and then press
[ OK].
3. Return to the weight measurement mode
Press [ POWER].