Shimadzu AP W-AD Series - Sample preparation for Analysis (Sample preparation) (W-AD; W Series only)

115
1
3
5
2
4
6
7
8
12
14
13
9
10
11
77 ApplicationsApplications
4. Enter the formation volumes
The ingredient name, weight and permissible error range will be displayed on the formation
setting screen, and the sample will be measures so that it is within the permissible range.
@
The weight and permissible error range will be compared against the formation and
determined accordingly.
(1) Enter the formation and then press [ OK].
@
If the display unit for the ingredient weight is [mL]
instead of [g], the display for the load placed
on the pan is for reference purposes only.
The balance is not able to weigh the specified
capacity (mL) of the solution, so it must be
inserted accurately with the use of the pipette.
@ The measured permissible error will be displayed on the entry screen if [ MENU] is
pressed during operations to enable the progress of the measurement to be checked
midway through.
(2) Weigh the specified ingredients and press [ OK]
when the stability mark is displayed.
(3) Save the results of the measurement and then start
taring.
(4) The total weight will be displayed once all
ingredients have been measured.
Buffer solution preparation data output
Once the buffer solution has been prepared, the
output process will always be started and [Printing]
will be displayed to make sure that the weight record
of the prepared ingredients is saved.
(5) The screen will return to the formation entry screen
when [ OK] is pressed, and it will then be
possible to commence the preparation of the buffer solution.

Sample preparation for Analysis (Sample
preparation) (W-AD/ W Series only)
This function supports sample collection when preparing samples for analysis.
Entering the required property weight, molecular weight and hydrate weight, etc., enables targets to be
calculated. The function also supports Sample preparation measurement operations by displaying on
one screen the required property weight that is included while carrying out measurements.
 Sample preparation for Analysis (Sample preparation)
1. Set the Sample preparation mode.
(1) Press [ MENU] when the weight is displayed,
and then Press [ LEFT].
(2) Select [ Mode Selection], and then press
[ OK].
(3) Select [Sample preparation], and then press [ OK].
*