Shimadzu AP W-AD Series - Precautions when moving the balance or shipping the balance for repair

157
1111
MaintenanceMaintenance
1
3
5
2
4
6
7
8
12
14
13
9
10
11

Precautions when moving the balance or shipping the balance for repair
Abide by the following precautions when moving the balance or shipping the balance for repair.
1. Remove all removable parts
Remove the pan inside the weighing chamber, pan supporter, shield plate, Adjustable
Windbreak Plate, stage, shield case, power unit, multi-stand, etc.
2. Move the balance
Either hold the balance in your hands and carry it or use the packaging box which the balance
was originally shipped in to move it.
[When holding the balance in hands to moving]
Securely hold the balance with both hands according to the steps below.
(1) Place both hands on the main body as shown in the
figure.
(2) Insert fingers under the main body and slowly and
gently lift.
Do not hold by the ceiling frame portion. Securely
hold using both hands by supporting the balance
from underneath the main body to move it.
!
CAUTION
The balance is a precision instrument. Handle it with care and protect it from impact.
Carry out warming up operation after the balance is finished being moved and installed in its new location.
^ [Warming Up] (P.27)
[When using the packaging box to moving]
Lift the balance as explained in the procedure for moving the balance by hand and place it in
the packaging box. The main body weighs approximately 10 kg. Be careful not to hurt your
back.
For the W-AD Series, remove the glass doors before placing in the packaging box.
^ [Removing the Glass Draft Shield] (P.156)