SICK DL100 User Manual

Operating instructions Distance measuring device DL100 – CANopen®
Operation at the measuring device
54 © SICK AG • Subject to change without notice • 8015416/ZPN2/2017-09-08
8.5.12 Menu „MF2“
This menu and the associated submenus can be used to set parameters
for the multifunction output MF2.
You can get to the menu "MF2" via the menu path:
Main menu →
→ Menu → → CANopn → → more → →
MFx On → → MF1 → → MF2
Push the
key so that the parameter "ActSta" is displayed.
Use the keys
and to browse within the menu. Push the key to
display the respective parameter value.
Requirements for the display
• Menu "more": Option "Yes"
• Menu "MFx On": Option "Enable"
Parameter Description
ActSta Select multifunction output level MF2.
Options
• ActLow: LOW-level at active output (opener/NC)
• ActHi: HIGH-level at active output (closer/NO)
Factory setting
• ActLow
Functn Select function for the multifunction output. Depending on the
selection, the corresponding submenu is displayed.
Options
• Dist
• Srvice
• Speed
Factory setting
• Dist
Dist / Srvice /
Speed
Depending on the selection for the parameter "Functn", the
corresponding submenu is displayed. For parameter descrip-
tion, see the respective table.
Count Nofurthersubmenuisdisplayedfortheoption“LsrO”.When
themultifunctioninputMF1isactive,thelaserisswitchedo.
Table 20: Menu "MF2"
Submenu "MF2 – Dist" This submenu corresponds to the submenu "Dist" in the menu "MF1".
→ Also see page 49, Table 16.
Submenu "MF2 – Speed" This submenu corresponds to the submenu "Speed" in the menu "MF1".
→ Also see page 50, Table 17.
Submenu "MF2 – Srvice" This submenu corresponds to the submenu "Srvice" in the menu "MF1".
→ Also see page 52, Table 18.

SICK DL100 Specifications

General

Brand	SICK
Model	DL100
Category	Measuring Instruments
Language	English