2 Safety information
2.1 General safety notes
This chapter contains general safety information about the safety laser scanner.
F
urther safety information regarding specific usage situations is provided in the respec‐
tive chapters.
WARNING
Ine
ffectiveness of the protective device
In the case of non-compliance, it is possible that the dangerous state of the machine
may not be stopped or not stopped in a timely manner.
b
Please read this document carefully and make sure that you understand the con‐
tent fully before working with the device.
b
Follow all safety notes in this document.
Laser class 1
CAUTION
If an
y operating or adjusting devices other than those specified in this document are
used or other methods are employed, this can lead to dangerous exposure to radiation.
b
Only use the operating or adjusting devices specified in this document.
b
Only follow the methods specified in this document.
b
Do not open the housing, except for the purposes of the installation and mainte‐
nance work specified in these operating instructions.
Figure 1: Laser class 1
T
his device complies with the following standards:
•
IEC 60825-1:2007
•
IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11, except for changes due to Laser Notice No. 50
dated 24/06/2007
Additional measures to shield the laser beam are not required (eye-safe).
2.2 Intended use
The safety laser scanner is an electro-sensitive protective device (ESPE) and is suitable
f
or the following applications:
•
Hazardous area protection
•
Hazardous point protection
•
Access protection
•
Mobile hazardous area protection (protection of automated guided vehicles)
The safety laser scanner must only be used within the limits of the prescribed and
specified technical data and operating conditions at all times.
2 SAFETY INFORMATION
10
O P E R A T I N G I N S T R U C T I O N S | S300 8010948/ZA21/2020-06-18 | SICK
Subject to change without notice
To Next Page
Loading...
Need help?
General
