Siemens HydroRanger 200 HMI - Page 369

Programming chart
G.1 Programming chart
HydroRanger 200 HMI
Operating Instructions, 06/2018, A5E36281317-AC
367
Parameter
Altered values for indices/point numbers
1
2
3
SmartLinx Reserved
Communications
Device Address (4.2.) (Page 267)
Protocol (4.4.) (Page 268)
Serial Baud Rate (4.5.) (Page 268)
Parity (4.6.) (Page 269)
Data Bits (4.7.) (Page 269)
Stop Bits (4.8.) (Page 269)
Modem Available (4.9.) (Page 269)
Modem Inactivity Timeout (4.10.)
(Page 270)
Parameter Index Location (4.11.)
(Page 270)
SmartLinx Hardware Testing
Hardware Status (3.2.12.1.)
(Page 264)
Hardware Status Code (3.2.12.2.)
(Page 264)
Hardware Error Count (3.2.12.3.)
(Page 264)
Smartlinx Module Type (3.2.12.4.)
(Page 265)
Smartlinx Protocol (3.2.12.5.)
(Page 265)
Communications Control (5.4.)
(Page 272)
Echo Processing
Blanking (2.2.6.) (Page 171)
Range Extension (2.2.7.) (Page 172)
Submergence Detection (2.11.2.8.)
(Page 224)
Shot/pulse Mode (2.1.17.)
(Page 168)
Long Echo Threshold (2.11.2.3.)
(Page 223)
Long Confidence (3.2.11.2.)
(Page 262)
Echo Strength (3.2.11.4.) (Page 263)