Siemens SINAMICS S110 - Page 104

Diagnostics
5.2 Diagnostics via STARTER
Function Manual
102 Function Manual, 01/2011, 6SL3097-4AB10-0BP3
In the STARTER commissioning tool, select the parameter screen "Measuring sockets" in
the project tree under the CU in the entry inputs/outputs in the tab Measuring sockets.
Note
Please see the online help for more information about parameterizing and operation.
Properties
 Resolution
8-bit
 Voltage range
0 V to +4.98 V
 Measuring cycle
Depends on the measuring signal
(e.g. actual speed value in speed controller cycle 250 μs)
Short-circuit-proof
Parameterizable scaling
Adjustable offset
Adjustable limitation
Signal chart for measuring sockets
/LPLWDWLRQ
0HDVXULQJVRFNHW
6FDOLQJ
7KHIROORZLQJDSSOLHVWR
PHDVXULQJGHYLFHV
5L! 0വ
>@!0HDVXULQJVRFNHW7
>@!0HDVXULQJVRFNHW7
1RWH
U>@LQGLFDWHVWKHVFDOLQJSHUYROW
7
7
\
\
[
[


$
'
0
9
S>@9
U>@
S>@

S>@

S>@
9
S>@9
U>@
U>@ U>@
9
\>9@
\>9@
\

\

9
9
;

;

\>9@
3

3

[>@

 
 

 


[>9@

[
>9@
S>@
9
2IIVHW
Figure 5-11 Signal chart for measuring sockets