Siemens SINUMERIK 804D sl

NCK start-up
10.5 Parameterize axis data
CNC Part 1 (NCK, PLC, drive)
148 Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
• MD36510 ENC_DIFF_TOL (measuring system synchronism tolerance)
Error response
• Alarm: "25105 Measuring systems are not synchronous"
and stopping the machine axes using a speed setpoint ramp whose characteristic is set in
• MD36610 AX_EMERGENCY_STOP_TIME (Time for braking ramp when an error occurs)
352),%86
'3GULYH
%UDNH
UDPS
&/$03B326B72/
67$1'67,//B326B72/
67$1'67,//B'(/$<B7,0(
326,7,21,1*B7,0(
6723B/,0,7B),1(
6723B/,0,7B&2$56(
)ROORZLQJHUURU
,63RVLWLRQPHDVXULQJV\VWHP
DFWLYH
(1&B=(52B021,725,1*
(1&B)5(4B/,0,7
$FWYDOSURFHVVLQJ
$FWYDOSURFHVVLQJ
(1&B',))B72/
(1&B&+$1*(B72/
$;B9(/2B/,0,7
6767,//B9(/2B72/
&217285B72/
&RQWURO
ORRS
0RGHO
&75/287B/,0,7
$;B(0(5*(1&<B6723B7,0(
3RVLWLRQ
FRQWUROOHU
6SHHG
VHWSRLQW
6HWSRLQWVIURP
,QWHUSRODWRU
VHWSRLQW
SURFHVVLQJ
Figure 10-18 Monitoring for SINUMERIK 840D sl:
Notice
MD36620 SERVO_DISABLE_DELAY_TIME (Switchoff delay servo enable)
must always be selected greater than
MD36610 AX_EMERGENCY_STOP_TIME (Time for braking ramp when an error occurs)
If this is not the case, the braking ramp cannot be kept.
Literature
Function Manual Basic Functions; Axis monitoring: Protection zones