Tips
13.9 Configuration of the drive with macros
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
213
13.9 Configuration of the drive with macros
Introduction
The drive components can usually be configured using configuration macros and/or the drive
wizard for HMI Advanced.
Drive configuration
It describes in detail how to configure the drive using configuration macros.
Start an appropriate macro; once it has been executed:
• The drive-set topology will have been written to the NCK
• The drive components will have been parameterized
See also
Commissioning using a drive wizard (Page 71)
Macros for commissioning (Page 265)
NCU 7x0 and NX1x Terminal Assignment (Page 270)
Procedure for calling ACX macros (Page 267)
To Next Page
Loading...
