CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
7
Table of contents
Preface ...................................................................................................................................................... 3
1 Introduction.............................................................................................................................................. 13
1.1 Commissioning manuals for SINUMERIK 840D sl ......................................................................13
1.2 Principle representation of SINUMERIK 840D sl components for commissioning......................15
1.3 Initial commissioning procedure...................................................................................................19
2 Safety information.................................................................................................................................... 21
2.1 Danger notices.............................................................................................................................21
2.2 ESD notices .................................................................................................................................23
3 Requirements for commissioning............................................................................................................. 25
3.1 General prerequisites...................................................................................................................25
3.2 Software and hardware requirements..........................................................................................26
3.3 Communication interfaces ...........................................................................................................28
3.4 Commissioning tool on PG/PC ....................................................................................................29
4 Example configuration ............................................................................................................................. 31
5 Power on and boot up.............................................................................................................................. 33
5.1 Operating and display elements for run-up..................................................................................33
5.2 NCK and PLC general reset ........................................................................................................35
5.3 Boot completed ............................................................................................................................37
6 Connect PG/PC with the PLC.................................................................................................................. 39
6.1 Start SIMATIC Manager...............................................................................................................39
6.2 Setting up the communication......................................................................................................40
7 PLC commissioning................................................................................................................................. 41
7.1 Creating a SIMATIC S7 project....................................................................................................41
7.1.1 Creating a project.........................................................................................................................42
7.1.2 Inserting a SIMATIC station 300..................................................................................................43
7.1.3 Insert NCU 7x0 in HW config .......................................................................................................44
7.1.4 Configuring the properties of the network interfaces ...................................................................45
7.1.5 Insert NX in HW Config................................................................................................................51
7.1.6 End hardware configuration and load to the PLC........................................................................53
7.2 Creating a PLC program..............................................................................................................54
7.2.1 Insert PLC basic program ............................................................................................................54
7.2.2 Modifying Ethernet machine control panel in OB100 ..................................................................56
7.3 Loading the project to the PLC ....................................................................................................57
7.4 Carry out NCK reset.....................................................................................................................59
To Next Page
Loading...
