Licensing
14.9 Assigning via Automation License Manager
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
243
14.9.5 How to refresh the navigation view: "Manage"
Background
After actions which add or remove elements in the navigation area of the navigation view:
"Manage" of the Automation License Manager (e.g. deletion of a control image (offline),
enabling/disabling of plug-ins), the view is normally refreshed automatically. If the view does
not refresh automatically after an operation, you can refresh the view manually.
Execution
Perform the following actions to refresh the navigation view: "Manage" manually:
1. Select the following nodes in the navigation area of the Automation License Manager: My
Computer
2. Refresh the view using one of the following options:
– Menu command: View > Refresh
– Key F5
– Toolbar:
Result
The navigation view of the Automation License Manager is refreshed. All sub-nodes under
the node: My Computer are closed.
The object view of the Automation License Manager shows the current nodes and drives of
the navigation area.
Note
All directories are closed when the view is refreshed. When you select key: ' * ' on the
numeric keypad, you can open all directories with a single key.
14.9.6 Displaying the license information of a piece of hardware
Background
To perform one of the following tasks with the Automation License Manager:
• Check the license information for the hardware
• Ascertain the license requirement for the hardware and align if necessary
• Assign new licenses to hardware and transfer updated license information including
License Keys to the hardware
you must display the license information for a piece of hardware.
To Next Page
Loading...
