Siemens SINUMERIK 804D sl

Fundamentals
15.8 Axis data
CNC Part 1 (NCK, PLC, drive)
286 Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
Special axes
Additional axes are all other channel axes that are not geometry axes. Unlike for geometry
axes (Cartesian coordinate system), no geometric context is defined for additional axes,
neither between additional axes or with respect to geometry axes.
Literature
Function Manual Basic Functions; Axes, Coordinate Systems, Frames, Workpiece numbers
IWS: Axes
15.8.1 Axis configuration
Introduction
The figure below shows the assignment between the geometry axes, special axes, channel
axes and machine axes as well as the names of the individual axis types. MD are used for
assignment.
&KDQQHO
&KDQQHO
JHRPHWU\D[LV>@
JHRPHWU\D[LV>@
JHRPHWU\D[LV>@
&KDQQHO
&KDQQHO
&KDQQHO
&KDQQHO
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
FKDQQHOD[LV>@
&KDQQHO
&KDQQHO
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
PDFKLQHD[LV>@
0'01B$;&21)B0$&+$;B1$0(B7$%
0'0$B63,1'B$66,*1B72B0$&+$;



&
:
%
=
<
;












0'0&B$;&21)B&+$1$;B1$0(B7$% 0'0&B$;&21)B0$&+$;B86('
0'0&B$;&21)B*(2$;B$66,*1B7$%0'0&B$;&21)B*(2$;B1$0(B7$%















&
:=0
%
=
<
;



=
<
;
Figure 15-7 Axis configuration