Siemens SINUMERIK 804D sl User Manual

9.4 Creating a ShopMill program...............................................................................................327
9.5 Program header...................................................................................................................328
9.6 Program header (for milling/turning machine)......................................................................330
9.7 Generating program blocks..................................................................................................333
9.8 Tool, offset value, feed and spindle speed (T, D, F, S, V)...................................................334
9.9 Defining machine functions..................................................................................................336
9.10 Call work offsets...................................................................................................................338
9.11 Repeating program blocks...................................................................................................339
9.12 Specifying the number of workpieces..................................................................................341
9.13 Changing program blocks....................................................................................................342
9.14 Changing program settings..................................................................................................343
9.15 Selection of the cycles via softkey.......................................................................................345
9.16 Calling technology functions................................................................................................350
9.16.1 Additional functions in the input screens..............................................................................350
9.16.2 Checking input parameters..................................................................................................350
9.16.3 Setting data for technological functions...............................................................................350
9.16.4 Changing a cycle call...........................................................................................................351
9.16.5 Programming variables........................................................................................................351
9.16.6 Compatibility for cycle support............................................................................................352
9.17 Measuring cycle support......................................................................................................353
9.18 Example, standard machining..............................................................................................354
9.18.1 Workpiece drawing...............................................................................................................355
9.18.2 Programming........................................................................................................................355
9.18.3 Results/simulation test.........................................................................................................366
9.18.4 G code machining program..................................................................................................368
10 Programming technological functions (cycles).........................................................................................371
10.1 Drilling..................................................................................................................................371
10.1.1 General................................................................................................................................371
10.1.2 Centering (CYCLE81)..........................................................................................................372
10.1.3 Drilling (CYCLE82)...............................................................................................................374
10.1.4 Reaming (CYCLE85)...........................................................................................................377
10.1.5 Deep-hole drilling 1 (CYCLE83)...........................................................................................379
10.1.6 Deep-hole drilling 2 (CYCLE830).........................................................................................383
10.1.7 Boring (CYCLE86)...............................................................................................................394
10.1.8 Tapping (CYCLE84, 840).....................................................................................................396
10.1.9 Drill and thread milling (CYCLE78)......................................................................................403
10.1.10 Positioning and position patterns.........................................................................................406
10.1.11 Arbitrary positions (CYCLE802)...........................................................................................408
10.1.12 Row position pattern (HOLES1)...........................................................................................411
10.1.13 Grid or frame position pattern (CYCLE801).........................................................................412
10.1.14 Circle or pitch circle position pattern (HOLES2)...................................................................414
10.1.15 Displaying and hiding positions............................................................................................417
10.1.16 Repeating positions..............................................................................................................419
Table of contents
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 13

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English