Licensing
14.9 Assigning via Automation License Manager
CNC Part 1 (NCK, PLC, drive)
246 Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
Requirements
The following requirements must be met for the license requirement alignment:
• The address data for the customer login (personalized login) is available:
– User name
– Password
• Control (online) or control image (offline)
An "online" control system file or an "offline" control system file with the relevant control
image (offline) is available.
Execution
Perform the following actions for license requirement alignment with a control system
(online) or a control image (offline):
1. Open the corresponding control system file in the navigation area of the Automation
License Manager and select the control system (online) or the control image (offline).
2. Select the menu command: License Key > Align requirement
3. Login via your customer login.
4. Start the Automation License Manager and perform the following actions: "Align
requirement", "Confirm requirement list" and "Transfer licenses". Follow the instructions
displayed on the screen.
Notice
Suggested license assignment
Carefully check the suggested license assignment. An adjustment may be required if:
• you wish to use a license number that differs from the number suggested
• you wish to use a license package rather than single licenses
• you wish to assign greater or fewer licenses than suggested for any reason
You can no longer undo the assignment independently.
The procedure for transferring the updated license information from a control image (offline)
to a control system (online) is described in Subsection:
"Transferring license information for a control image (offline) to a control system (online)"
Result
A new License Key has been generated and loaded to the control (online) or the control
image (offline).
To Next Page
Loading...
