Fundamentals
15.4 Macros for commissioning
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
269
Occurring operator errors
Operator errors that frequently occur when starting macros include:
• incorrect status of p9
• active release to the modules
Note
If you have doubts, load the factory settings prior to executing a macro.
See also
Activate the factory settings (Page 69)
Update the component firmware with a macro (Page 211)
Drive components macro call (Page 214)
To Next Page
Loading...
