4
01/2008 Machine operating area
4.3 Reference point approach
4
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 4-113
Machine manufacturer
Your machine manufacturer will instruct you how to select axes if you
intend to enter more than nine.
Additional information
The sequence in which axes must be referenced can be defined by
the machine-tool manufacturer.
The NC cannot be started in Automatic mode until all axes with a
defined reference point (see machine data MD) have actually reached
this point.
To Next Page
Loading...
