Siemens SINUMERIK 840Di sl - Copying Workpieces with Job Lists; Archiving Workpieces with Job Lists in the Case of M:N

2
Operator Components/Operating Sequences 01/2008
2.7 Job list
2
©Siemens AG 2008 All rights reserved.
2-80 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2.7.6 Copying workpieces with job lists
This function only applies to the "Program" operating area.
When you copy under "Services", the names remain unchanged.
Sequence of operations
Manage
programs...
The "Manage programs" softkey in the "Program" operating area must
be pressed.
Copy
Position the cursor on the file that you want to copy and press the
"Copy" softkey.
The file is marked as the source for copying.
Paste
OK
Press the "Insert" softkey, specify another name if required
and confirm with "OK".
2.7.7 Archiving workpieces with job lists in the case of M:N
Function
When archiving workpieces that contain job lists of the same name, in
the case of M:N, you are asked whether the job lists to be unloaded
are to be executed. You can terminate the action with "Abort",
otherwise all job lists are executed and archiving is then started.
Sequence of operations
Data from
In the "Services" operating area, press the "Data from" softkey. The
"Programs/Data" file tree is displayed.
The vertical softkey bar changes.
Please refer to Chapter "Reading out data" in "Services" operating
area for additional sequences of operation.
■