Siemens SINUMERIK 840Di sl - Spindle Data

5
Parameters operating area 01/2008
5.5 Setting data
5
© Siemens AG 2008 All rights reserved.
5-224 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Additional information
The limit values for the maximum and minimum permissible values are
defined in the machine data.
5.5.3 Spindle data
Function
Max./min.
The value entered for the spindle speed in the fields max./min. must
be within the limit values defined in the machine data.
Programmed
Programmable upper speed limit (G96) for constant cutting speed.
Sequence of operations
Setting
data
Press the "Setting data" softkey.
The vertical softkey bar changes.
Spindle
data
Press the "Spindle data" softkey.
The "Spindle data limitation" window opens.
Edit spindle data
Position the cursor bar on the appropriate input field and enter a new
value.
or:
Select a new value using the <SELECT> key.
Additional information
• The limit values for the maximum and minimum permissible values
are defined in the machine data.
• The "Spindle data" function is displayed only if a spindle is
configured.