Siemens SINUMERIK 840Di sl - Switching On;Switching off the Control

1
Introduction 01/2008
1.3 Switching on/switching off the control
1
© Siemens AG 2008 All rights reserved.
1-20 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
1.3 Switching on/switching off the control
Function
Switching on
A variety of methods can be employed to switch on the power supply
to the control system or to the whole plant.
Machine manufacturer
Please follow the machine manufacturer's instructions!
A
fter the control has been switched on, the "Reference point
approach" display or another main screen programmed by the
machine manufacturer will appear.
Machine
Channel Reset
Program aborted
Jog
MKS Position.Repos-Versch.
+ X 900.000 mm 0.000
- Y -156.000 mm 0.000
+ Z 230.000 mm 0.000
MCS Position
+X900.000mm0.000
-Y-156.000mm0.000
+Z230.000mm0.000
-X 0.000 mm
+Y 0.000 mm
+Z 0.000 mm
+0.000mm
Tool
preselected tool :
G0 G91
Master spindle S1
Act. + 0.000 rev./min
Set 0.000 rev./min
Pos. 0.000 deg.
0.000 %
Power [%\
Feedrate mm/min
Act. 0.000 0.000 %
Set 0.000
REF
Switching off
Please follow the instructions below for switching off the control or the
entire system!
Machine manufacturer
Please follow the machine manufacturer's instructions!