Siemens SINUMERIK 840Di sl - Sorting and Saving Version Data

8
01/2008 Diagnostics operating area
8.5 Calling theversion screen
8
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 8-415
Sequence of operations
Service
displays
Press the "Service displays" softkey.
The horizontal softkey bar changes.
Version
Open the "Version" window with the following softkeys:
NCU
version
"NCU version" for the version data of the NCU and
HMI
version
"HMI version" for the version data of the HMI.
Cycle
version
"Cycle version" Version data for each of the cycle packages
Defini-
tions
"Definitions" The version data for definitions
Hardware
version
"Hardware version" for the version data of the hardware.
(only available for SINUMERIK solution line)
Option: Compile cycles If "Compile cycles" is available on the NCK, the version is displayed.
Use the "Page" keys to scroll up and down.
8.5.1 Sorting and saving version data
Function
There are various sorting functions for the following version lists:
• NCU version
• HMI version
• Cycle version
• Definitions
Sort
In the left-hand part of the pane for sorting, you can select a sort
criterion from the column designations in the list by pressing the
Select key. In the right-hand pane you can choose from descending
and ascending sorting sequence for the selected sort criterion.