Siemens SINUMERIK 840Di sl - Protocol

6
"Program" operating area 01/2008
6.9 Managing programs
6
© Siemens AG 2008 All rights reserved.
6-354 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Additional information
• The system checks whether a program may be executed when the
program is called (after selection via operator input or from part
program). If you want it to be enabled, you must enable it
beforehand.
(See also Chapter 6 "Changing properties of file/directory/archive")
6.9.11 Protocol
Function
If you are working on the hard disk, the following data are included in
the log:
• Name of program currently being executed (execution from
external source)
• Names of previously executed programs
• Prompts: e.g. "Do you really want to delete job?"
• Error list: Names of previously executed programs in which an
error occurred.
Sequence of operations
Log
Press the "Log" softkey.
The "Job log for programs" window opens.
Depending on the status of the current program run, the following
functions can be executed by means of the vertical softkeys
(e.g. when prompt "Really delete?" is displayed in the "Query"
window):
Yes
• The program currently being executed is deleted.
All
• All programs in the current job list are deleted.
No
• The program currently being executed is not deleted.
Stop
• The program currently being executed is aborted.