7
01/2008 Services operating area
7.3 Data selection
7
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 7-377
7.3.2 Data on the hard disk
Function
General
In addition to the NC working memory, SINUMERIK controls with HMI
are provided with a hard disk. It is thus possible to store all data or
programs which are not required in the NC on the hard disk. All data
are displayed in a single file tree on the user interface.
In the "Services" operating area, all files on the hard disk and in the
NC memory can be:
• Managed (new, load, unload, copy, delete, change properties),
• Saved for a series commissioning (NC, PLC and HMI data) and
• Downloaded to the NC memory (programs and files).
Copy to diskette
When you copy to diskette the full file names are stored on the
diskette.
Additional information
The end of block character is displayed not as "L
F
" but as " ¶".
System queries
The system behavior when copying/creating data (e.g. overwrite
existing files or query first) can be configured for all operating areas.
Query dialogs
"Save as"
In the "Commissioning" operating area, press the HMI/System
settings/Query softkeys to specify that a dialog box is to appear before
files are overwritten. Otherwise, the files are overwritten without
prompting or a copy is created.
To Next Page
Loading...
