6
"Program" operating area 01/2008
6.8 Program simulation
6
© Siemens AG 2008 All rights reserved.
6-316 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6.8.1 Using the simulation function
Sequence of operations
Main menu After a program or workpiece is selected, the Simulation softkey is
made available.
Turning technology main screen
When you select a simulation via a workpiece, first the machining list
from the Channel/spindle menu (see below) is displayed. Press OK to
exit the menus. The main menu is now displayed.
Horizontal main menu
End
simulation
Terminate simulation. Return to the program overview or ASCII editor.
You need the correct password for this.
Loaded
data
or
Match
data
With the correct password you can match the simulation data with the
corresponding "NC active data" (setup data, tool data, machine data,
cycles).
See "Match data" menu
Timing
Tabular evaluation of the execution times for the current simulation
session (see Chapter "Downtime settings")
Search run
The function "Search run" can be used to start the simulation
selectively for specific sections.
To Next Page
Loading...
