6
01/2008 "Program" operating area
6.8 Program simulation
6
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 6-317
Edit
program
Activate the ASCII editor from the current simulation interruption
status (cursor position synchronized with graphic).
Return to simulation with "Close editor"
Channel /
spindle
Program-specific channel and spindle assignments (activate
processing list in combination with the overlay principle).
See menu "Channel/spindle"
Vertical main menu
or
Simulation START or simulation STOP
(program-by-program in conjunction with the machining list)
Simulation RESET
The previous execution result is discarded for the program at hand
and a polymarker is displayed.
Simulation single block ON/OFF - SINGLE BLOCK
(status display in header SBL1, SBL2 or SBL3)
Milling Turning
or
Technology-specific workpiece views
Milling: Top view Turning: External view (front)
or
Milling: Default top view Turning: Full section, frontal
and front view
(free selection under "Details...")
or
Milling: 3D view Turning: Default half-section, frontal
or wire model Front and wire model
(free selection under
"Details...")
Details
Select status-dependent detail menu (active view, alarm status)
Settings.
or
Select user and vendor-specific setting menus
in RESET or STOP state or
in RUN state display current simulation override
To Next Page
Loading...
