Siemens SINUMERIK 840Di sl - Standard Full Keyboard

2
01/2008 Operator Components/Operating Sequences
2.1 Operator panel front
2
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 2-29
2.1.2 Standard full keyboard
A full standard keyboard can be connected. However, a machine
control panel is required in addition to this keyboard.
The special function keys of the operator keyboard can also be used
with the full PC keyboard. The following table shows how the
horizontal and vertical softkeys and the special keys for the operator
panels are mapped onto the PC keyboard keys:
Softkey assignment
Full
Full
The following table shows how the hardkeys of the MF 2 keyboard on
the PC are mapped onto the keys for the operator panels:
Hardkey assignment
MFII
Hard-
key
Hard-
key
Hard-
key
Hard-
key
Hard-
key
Hard-
key
Hard-
key
MFII
out
Hard-
key
Position
Caution
The full standard keyboard does not meet the requirements (EMC) of
a SINUMERIK control. For this reason, it can be used only for
installation and service purposes.
Additional information
Since the English version of Windows is used in the control, the
keyboard language is English. A different keyboard language cannot
be set.