Siemens SINUMERIK 840Di sl - Syntax Description for Job Lists

2
Operator Components/Operating Sequences 01/2008
2.7 Job list
2
©Siemens AG 2008 All rights reserved.
2-72 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2.7.1 Syntax description for job lists
Explanation
The job list syntax consists of 3 instructions
• Load instruction LOAD
• Select instruction SELECT
• Copy instruction COPY (for m:n link only)
Notes
As regards the job list commands, a distinction must be made
between an m:n network and a 1:1 link between the HMI and NCs.
It is advisable to use the instruction LOAD for a 1:1 link and COPY for
an m:n link, at least for global programs and, in particular, cycles used
in several NCUs.
Comment
A
ll terms placed inside "brackets" or ";" are comments and are ignored
when the job list is processed.
Description of syntax
LOAD [source]
The LOAD instruction loads one or several files from the HMI into the
NC working memory, deleting the source file on the HMI. In other
words, the files are only stored in one location.
This instruction is recommended for a 1:1 link.
[source] is [path]/[name]
The path/name defines the relevant path within the file tree of the data
manager.
Wildcards (i.e., *) may also be used in the name.
Examples:
LOAD *
(Loads all files from the workpiece directory of the job list)
LOAD /MPF.DIR/*
(Loads all files from one directory, e.g., in this case all files
from part programs (MPF.DIR))
LOAD PART1.MPF
(Loads one file, e.g., PART1.MPF from the currently selected
workpiece directory of the job list)
LOAD /SPF.DIR/PART1.SPF