7
Services operating area 01/2008
7.1 Services main screen
7
© Siemens AG 2008 All rights reserved.
7-364 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Archive
• The contents of the "Archives" directory on the hard disk are
displayed. Enter the name of the new archive file.
NC card
• The contents of the archives directory on the NC card are
displayed. Enter the name of the new archive file.
Start
When exporting data from diskette/archive, press the "Start" softkey,
otherwise the control is ready to receive immediately.
The data transfer is initiated. The vertical softkey bar changes. The
softkey labeling of the target area changes to "Stop". To abort data
transmission, press the relevant softkey again.
Additional information
Archives to be stored on diskette need not fit completely on a single
diskette. Distribution of the archive over several diskettes is
supported.
When archiving workpieces that contain job lists of the same name, in
the case of m:n, you are asked whether the job lists to be unloaded
are to be executed. You can terminate the action with "Abort",
otherwise all job lists are executed and archiving is then started.
7.1.3 Displaying the log
Function
A job log is generated automatically for each transmission. You can
press the “Log” softkey to display the following information:
• The transmitted files in the job list
• The error list, which displays messages regarding whether the
transmission has been successful or not.
Sequence of operations
Services
The "Services" operating area is selected.
To Next Page
Loading...
