Siemens SINUMERIK 840Di sl - 4.6.2 Program overview

4
Machine operating area 01/2008
4.6 Automatic mode
4
© Siemens AG 2008 All rights reserved.
4-134 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
4.6.2 Program overview
Function
After selection of a workpiece or program overview, individual
workpieces or programs can be enabled or disabled for execution.
Sequence of operations
"AUTO" mode is selected in the "Machine" operating area.
The appropriate channel is selected.
The channel is in reset state.
The workpiece/program to be selected is in the memory.
Program
overview
An overview of all workpiece directories/programs that exist is
displayed.
Position the cursor on the desired workpiece/program.
Vertical softkeys
Select the workpiece/program for execution:
Selection
The name of the selected workpiece is displayed on the screen in the
"Program name" field at the top. The program is also loaded and
selected for processing.
Change
enable
The selected workpiece/program is enabled
(X) or disabled (no "X").
A selection can only be made when the workpiece/program is
enabled.
Explanation of other softkeys:
All existing programs of a particular type are displayed via the
horizontal softkeys:
Work-
pieces
Display of all existing workpiece directories
Part
programs
Display of all existing part programs
Sub-
programs
Display of all existing subprograms
Standard
cycles
Display of all existing standard cycles