8
Diagnostics operating area 01/2008
8.5 Calling theversion screen
8
© Siemens AG 2008 All rights reserved.
8-414 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
8.4.7 Action log
Action log
A existing action log can be displayed with the corresponding
authorization (access level: manufacturer).
For configuration of the action log, see
IM4 Commissioning Manual HMI-Advanced
8.5 Calling theversion screen
For SINUMERIK powerline
Function
The version data of the installed system software are output in the
Version display:
Sort and save functions are available for the displayed version data.
Version displays saved as ASCII files can be edited as required or
sent to the hotline in the event of an error.
For SINUMERIK solution line
Detail
The version data displayed under “NCU Version” state the software
versions on the CF board: This especially applies to measurement
cycles and cycle versions. The measurement cycles and cycles that
are used by HMI-
dvanced are available on the hard disk of the PCU.
Their version can be queried via the horizontal softkeys.
With the “Detail” softkey, you can query further information about a
version, for example, to pass it on to hotline support personnel if
service is required.
Checking is performed the first time the version display is accessed.
In the case of SINUMERIK solution line, the version number is 8 digits
long and structured as follows:
V xx.yy.zz.nn
xx: Major Release
yy: Minor Release
zz: Service pack
nn: Hotfix Number
To Next Page
Loading...
