7
Services operating area 01/2008
7.4 Transfer display MD from HMI Embedded
7
© Siemens AG 2008 All rights reserved.
7-380 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
7.4 Transfer display MD from HMI Embedded
Function
Usage
When migrating from the HMI component HMI Embedded (PCU20) to
HMI Advanced (PCU50/PCU70) you may like to transfer tried and
proven display machine data from the HMI Embedded configuration to
the HMI Advanced configuration, e.g. for use with ShopMill/ShopTurn.
The following section describes how to proceed for to transfer the
machine data.
Starting point
Display machine data reside on the NCU for HMI Embedded, and on
the hard disk of the PCU50/PCU70 for HMI Advanced.
Case 1:
Case 2:
Anzeige-MD
Anzeige-MD
HMI-Embedded
NCU1
HMI-Advanced
Anzeige-MD
NCU1
Netz-LW
Floppy Disk
Anzeige-MD
HMI-Advanced
NCU2
PCU 50
PCU 50
PCU 20
HMI-Embedded
Sequence of operations
The transfer consists of two steps:
• Copy the display machine data with HMI Embedded
• Read into the PCU50/PCU70 under HMI Advanced
Case 1 acc. to diagram
On the HMI Advanced system: Services operating area
Transfer display machine data to the display if not yet activated:
Services → Select data
Select "Display machine data"
OK
Copy display machine data:
Services → Manage data
Display machine data\BDxxyy.tea
Copy
To Next Page
Loading...
