6
01/2008 "Program" operating area
6.8 Program simulation
6
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 6-325
6.8.2 Simulation settings
"Settings..." menu
Only accessible from the RESET or STOP state of the simulation
(e.g., single block mode)
Other settings can only be displayed/hidden if you enter a valid
password via the “Options” softkey.
Load
standard
Options
on/off
or
Options
on/off
Load manufacturer-specific default settings
(See data management: \DP.DIR\SIM.DIR\SIMINI_M.COM for milling
or
SIMINI_T.COM for turning and differential files in the \USER directory.
Display/hide optional setting parameters in the current window,
(Initial setting is options off)
Change
default
The default values can be modified according to the manufacturer's
requirements if a valid password is entered.
The changes to the manufacturer-specific default set values in files
"SIMINI_M.COM" and "SIMINI_T.COM" are used as differential
parameters in the files "DPMWP.INI" and "DPTWP.INI" in the \USER
directory and taken into account for all new workpieces.
Downtime
settings
With the correct password, you can set the desired computation mode
for secondary times and selectively define estimated secondary times
for the NC functions T, S, M and H.
Settable parameters: See Chapter “Downtime settings”
The input screen has been changed to enable selection between the
machine data and an individual tool change time (as previously).
To Next Page
Loading...
