2
Operator Components/Operating Sequences 01/2008
2.5 General operating sequences
2
©Siemens AG 2008 All rights reserved.
2-50 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2.5 General operating sequences
Keys
A range of keys are available in the various operating areas and
menus. The function of the keys is the same in all operating areas.
This identical functionality applies only if the operating areas are left
intact as supplied by Siemens AG and no modifications have been
configured by the user.
Additional information
It is possible to customize the menu trees. In this way, users are able
to define softkeys according to their individual needs. Due to this
capability, the menus and softkeys on your control may be different to
those described in this Operator's Guide.
References Commissioning Manual HMI Advanced,
see Chapter “Generating user operator menus”
Functions
The following section describes functions which you can select in
several operating modes.
2.5.1 Program overview and program selection
Function
After selection of a workpiece or program overview, individual
workpieces or programs can be enabled or disabled for execution.
Sequence of operations
"AUTO" mode is selected in the "Machine" operating area.
The appropriate channel is selected.
The channel is in reset state.
The workpiece/program to be selected is in the memory.
An overview of all workpiece directories/programs that exist is
displayed.
Position the cursor on the desired workpiece/program.
Select the workpiece/program for execution:
To Next Page
Loading...
