7
Services operating area 01/2008
7.2 Managing data
7
© Siemens AG 2008 All rights reserved.
7-368 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Loadable compile cycles
You can use the HMI user interface to transfer the loadable compile
cycles (CC) easily to the NC using an NC card. Further storage
locations are any external drive, such as a disk drive, USB memory
module or network drives 1 to 4. This storage location appears in the
Service operating area under "Manage data".
You can also use the SinuCom NC or SINUCOPY-FFS
commissioning tool to transfer the loadable compile cycles into the
control.
Load a compile cycle
Each time the NC is booted, all loadable compile cycles with the
extension .ELF, which are available in the /_N_CCOEM.DIR directory,
are automatically loaded into the NCK system software. Loadable
compile cycles are always loaded on an NCU reset.
For a detailed description of how to install compile cycles, please see:
/FB3/, TE0 Installation and Activation of Loadable Compile Cycles.
7.2.3 Copying and inserting
Function
Copy compile cycles
Following a reset, the optionally available compile cycles are stored on
the NCU in the Flash File System (FFS) in directory /_N_CCOEM.DIR
and can be copied selectively from/to an external drive, disk or NC
card.
It is thus possible to archive individual compile cycles.
The "Insert" function is available in addition to "Copy".
You can copy
1. A single file,
2. Several files or
3. A complete directory.
You can display any existing compile cycles in the Diagnostics
operating area under Service displays/Version/Compile cycles.
Sequence of operations
Manage
data
Press the "Manage data" softkey.
The horizontal and vertical softkey bars change.
Select the source files that you wish to copy.
To Next Page
Loading...
