Siemens SINUMERIK 840Di sl - Page 318

6
"Program" operating area 01/2008
6.8 Program simulation
6
© Siemens AG 2008 All rights reserved.
6-318 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Notes
1. On simulation START and program change, any 3D view currently
displayed is automatically deselected and replaced by a
technology-specific default view.
2. If you repeat machining simulation START after end of program
M2/M30 of the last program to be simulated, the simulation
channels are usually RESET and the simulation graphic reset if no
machining list has been activated with the "Channel/spindle"
softkey.
3. If the machining list under "Channel/spindle" is activated, the
overlay principle takes effect for the listed programs, where global
reset in combination with a simulation START is only activated
after a query on the last M2/M30.
4. New selection or reselection of one of the listed workpiece views is
implicitly linked to automatic screen size adjustment.
5. In the case of "turning" technology, drills and milling cutters
in the G18 plane can only be displayed as polymarkers (cross
symbol) in the side views. Only the tool center point path
without the tool body is displayed.
The tool is visible on the front face view (G17) or on peripheral
surface processing (G19).
“Details...” menu
Standard horizontal
Milling Turning
Top
view
or
External
view
Front-
view
or
Half
section
Side
view
or
Full
section
Wire
model
or
Wire
model
Face
end
Periph.
surface
Assuming 2 window views with no alarm status:
• Default when milling: “Top view and front view”
• Default when turning: “Half-section and wire model”
With 2 window views only:
Free selection of the different views in window activated by means of
ditto
ditto
ditto
ditto
ditto