Siemens SINUMERIK 840Di sl

To Next Page

To Previous Page

Contents 01/2008

xiv SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition

7.3.1 Special directories and memory areas....................................................................7-376

7.3.2 Data on the hard disk ..............................................................................................7-377

7.4 Transfer display MD from HMI Embedded..............................................................7-380

7.5 V.24 interface ..........................................................................................................7-382

7.5.1 Parameterizing the V.24 interface...........................................................................7-382

7.5.2 Using the V.24 interface..........................................................................................7-386

Diagnostics operating area ...........................................................................8-391

8.1 Diagnostics main screen.........................................................................................8-392

8.2 Remote diagnostics.................................................................................................8-394

8.3 Alarms and messages.............................................................................................8-394

8.4 Service displays ......................................................................................................8-396

8.4.1 Service axis .............................................................................................................8-398

8.4.2 Service drive............................................................................................................8-399

8.4.3 Service SI (Safety Integrated) .................................................................................8-400

8.4.4 Systemressourcen anzeigen...................................................................................8-412

8.4.5 Configuration data output........................................................................................8-413

8.4.6 Communication error log.........................................................................................8-413

8.4.7 Action log.................................................................................................................8-414

8.5 Calling theversion screen........................................................................................8-414

8.5.1 Sorting and saving version data..............................................................................8-415

8.5.2 Display the version screens for cycles....................................................................8-416

8.5.3 Cycle version output................................................................................................8-419

8.5.4 Displaying loadable compile cycles ........................................................................8-419

8.6 Interrogating the PLC status ...................................................................................8-421

8.6.1 Changing/deleting a value.......................................................................................8-422

8.6.2 Assign symbolic PLC addresses.............................................................................8-423

8.6.3 Select operand screens for PLC status ..................................................................8-427

8.6.4 File functions ...........................................................................................................8-428

Commissioning operating area.....................................................................9-429

9.1 Startup main screen ................................................................................................9-430

9.2 Machine data...........................................................................................................9-432

9.3 NC ...........................................................................................................................9-434

9.4 PLC .........................................................................................................................9-435

9.5 Optimization/test (SINUMERIK powerline) .............................................................9-436

Maintenance..................................................................................................10-439

10.1 Operating data.......................................................................................................10-440

10.2 Cleaning ................................................................................................................10-441

Siemens SINUMERIK 840Di sl - Page 14