Siemens SINUMERIK 840Di sl User Manual

4
01/2008 Machine operating area
4.6 Automatic mode
4
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 4-151
Overstore without single block:
The main menu for "AUTO" mode is selected.
Cycle Stop
Stop the program by pressing "NC Stop".
Overstore
The "Overstore" window is opened.
In this window, you can now enter the NC blocks that are to be
executed.
Cycle Start
The blocks you have entered are executed, the "Current block"
window is opened and the softkeys disappear. The "Overstore"
window and associated softkeys are not displayed again until the
control switches to the "Channel interrupted", "NC Stop" or "NC
Reset" state.
More blocks can be added (to the overstore buffer) when these blocks
have been executed.
Additional information
• You can close the window and exit the Overstore function by
pressing the "Recall" key. You have now exited the Overstore
function.
• You cannot change operating modes until you have deselected
"Overstore" with the "Recall" key.
• The program that was selected before Overstore is now resumed
in "AUTO" mode when you press "NC Start" again.
• Overstore does not alter the programs stored in the part program
memory.

Siemens SINUMERIK 840Di sl Specifications

General

Brand	Siemens
Model	SINUMERIK 840Di sl
Category	Control Unit
Language	English