Siemens SINUMERIK 840Di sl - Page 188

5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-188 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Search &
position.
The "Find tool/location" window appears.
• Search
− Tool:
Enter the tool name and Duplo number and start the search
with OK.
The cursor is positioned on the tool found.
− Location:
Enter the magazine and location number and start the search
with OK.
The cursor is positioned on the tool found.
• Positioning
Select the "Position" softkey,
tool/location is moved to loading point. If there is more than one
possible loading point, a window is opened. You can select the
correct one with the cursor.
Next
magazine
The locations of the next magazine are displayed in the magazine list.
You can only scroll forwards. When you reach the last magazine, the
display returns to the first magazine.
(Names assigned by
user)
Vertical softkeys (tool list)
Selection of a table structure configured by the user
(if configured), e.g.:
Tool
list 1
• General data
Tool
list 2
• Geometry data
Tool
list 3
• Wear data
Tool details
You can display and edit the complete data of a tool (as in the
magazine list).
Tool
from CC
The tool data are read from a code carrier and entered in the tool list
(you can then edit the data).
Tool in
cabinet
Select the tool in the tool cabinet.
The tool data are read from there and entered in the tool list.
A list display appears for which you can parameterize a filter for the
tool number, duplo number and tool type. The list displays all the tools
that fulfill the filter criteria. You can select the tool you require from the
list.