Siemens SINUMERIK 840Di sl - Page 190

5
Parameters operating area 01/2008
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
5-190 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Note
The data you enter are always updated immediately (without
prompting). You can edit the properties of the new tool by pressing the
"Tool details" softkey.
It is not possible to edit the data directly in the table.
You can only edit the name and type of a tool by selecting Create
New, not via Tool details.
To change a name, you have to create a new tool and delete the old
one.
(Names assigned by
user)
Vertical softkeys (working offset list)
Selection of a table structure configured by the user
(if configured), e.g.:
W. offset
list 1
• General data
W. offset
list 2
• Geometry data
W. offset
list 3
• Wear data
Tool data
You can display and edit the complete data of a tool (as in the
magazine list).
Find
D number
Find an entry with a specific D number/DL number.
• Enter the D number and DL number you want to find in the search
window.
• Confirm with "OK". If a matching entry is found, the cursor jumps to
the corresponding line. If you have not specified a DL number, the
cursor is positioned on the first line of the matching tool.
Current
D number
The D number of the current tool is determined and displayed.