5
01/2008 Parameters operating area
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-201
Additional information
In the lists, you can parameterize a filter for loading tools. A list display
appears for which you can parameterize a filter for the tool ID, duplo
number and tool type. The list then displays the tools in the tool
cabinet that meet the filter criteria. By selecting it from the list, you
accept the tool.
Sequence of operations (loading from the "Magazine list")
Tool
managem.
Press the "Tool management" softkey.
The "Magazine list" is displayed.
The horizontal and vertical softkey bars change.
Magazine
list
The "Magazine list" is selected.
The appropriate magazine is selected.
Load
Press the "Load" softkey.
The vertical softkey bar changes again.
Manual data input
(with search for empty
location)
If you want to enter data directly in the table, you must first find a
suitable empty location in the magazine.
There are four methods by which you can find an empty location for
different tool sizes in combination with location types:
1. Directly in the magazine list ("Manually").
2. Via a user-defined location
e.g., "oversize" (name configured by machine manufacturer)
3. Via the "Find empty location" softkey
4. Via the "To loading point" softkey
Additional information
Values are checked for validity when you enter a tool type in the lists.
Only known tool types are permitted.
Searching directly in the magazine list
Position the cursor on the location of your choice in the magazine list.
Search via user-defined location (example)
The assignment of the softkeys is configured by the machine
manufacturer.
To Next Page
Loading...
