Siemens SINUMERIK 840Di sl - Page 205

5
01/2008 Parameters operating area
5.3 Tool management
5
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 5-205
Select the appropriate list via softkey:
Magazine
list
• "Magazine list"
A tool is to be physically removed from a magazine location. You
can configure whether the corresponding NC block is also removed
from the TO memory.
Select the magazine and the tool to be unloaded (select the tool
with the cursor).
or
Tool list
• "Tool list"
The NC block is to be unloaded from the memory. Select the tool
to be unloaded (select the tool with the cursor).
Unload
Select the "Unload" softkey.
The vertical softkey bar changes.
Tool in
cabinet
The tool data of the selected tool are stored in the tool cabinet on the
hard disk. This allows you to load the tool with the same data again at
a later point.
Data on CC
in cabinet
If a code carrier is installed, the tool data are automatically stored
there. This allows you to load the tool with the same data again at a
later point.
From
magazine
The selected tool is unloaded.
The corresponding line is deleted from the magazine list.
The entries in the magazine number and location number columns are
removed from the tool list.
"Unload directly from spindle" is only possible if the buffer is selected
and the cursor is positioned on the location of the spindle.
To exit the screen without unloading the tool, select another display
in the vertical softkey bar before pressing "Start".
Delete tool
The tool data of the selected tool are deleted from the TO memory. If
the tool is in a magazine location, it is unloaded and deleted.
If a host computer is connected, the data are transferred to the host
computer each time a tool is deleted or unloaded.