Siemens SINUMERIK 840Di sl - Page 286

6
"Program" operating area 01/2008
6.6 Multiple editor (option)
6
© Siemens AG 2008 All rights reserved.
6-286 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Softkeys
OK
The “OK” softkey is used to accept the current settings – under the
assumption that the setting check was positive. The display in the m
ASCII view is then completely built-up again.
Abort
The “”Abort” softkey, the channel selection dialog box is executed
without any further action.
HSK16 channel selection
dialog box in the single
ASCII view
If HSK16 is pressed in the single ASCII view, the same dialog box is
obtained – with the following difference: The cursor is located on the
selection icon bar yes/no and returns to the single ASCII editor as long
as nothing was changed regarding the channel pre-selection;
otherwise, it returns to the multiple ASCII editor. The cursor in the
opened dialog box is located on the graphic step view.
Re-numbering HSK11
The function is only effective for the channel currently in focus. This is
the reason that it remains in the ETC bar.
HSK13 settings
The settings made become effective for all opened dialog boxes (not
only those that are displayed). This is the reason that a return jump is
made to the main bar.