6
01/2008 "Program" operating area
6.8 Program simulation
6
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 6-323
Start label
Path label from which a program is simulated. If this is not specified,
simulation takes place from program start.
Stop label
Path label up to which a program is simulated. If this is not specified,
simulation takes place to program end.
(See also "Multi-channel, section by section program simulation".)
Channel
Processing channel in the SIMNCK interpreter
Spindle
Turning: MS main spindle, CS counterspindle, var variable controlled
via NC vocabulary word.
(Milling: currently unused)
Off
Skipping The designated section/program is not simulated in the
current session.
Channel
settings
Milling
Turning
Leads to the manufacturer-specific channel settings (subject to correct
password).
Constant machine arrangement
Machine arrangement in front or behind turning center.
Spindle
settings
Milling
Drehen
Leads to the manufacturer-specific spindle settings (subject to correct
password).
currently unused
Defines longitudinal offset for main spindle and counterspindle,
longitudinal mirroring on/off, NC keyword definitions for spindle
switchover.
Copy
Copy selected line of machining list to clipboard.
Paste
Insert the machining list line that was copied/deleted from the
clipboard at the position of the selected line (the selected line is
moved down one row).
Delete
Delete the selected line from the machining list
To Next Page
Loading...
