7
Services operating area 01/2008
7.2 Managing data
7
© Siemens AG 2008 All rights reserved.
7-372 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Change the file type
Use the "Edit" key (displayed next to the type bar) to show the list of
file types to which the file may be converted.
Only the file types are displayed which are permissible in the directory
where the file is located.
Use the "Direction" keys to display the new file type.
Confirm your selection with the "Input" key (displayed next to the file
type you have selected).
OK
The file is assigned the new file type.
Additional information
• No check is made to determine whether or not the file contents
may be stored under the new file type!
• The contents of a file are not altered when the file type is
converted.
• All data types may be stored in the "Clipboard" directory.
• The file type is displayed in the properties window for network
drives or disk, and the extension with 0 to 3 characters can be
modified in the "Type" input field.
To Next Page
Loading...
