7
01/2008 Services operating area
7.5 V.24 interface
7
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 7-387
“OK” softkey
The actual settings are activated and saved in the parameter file. If a
parameter file name is displayed in the header line, then the displayed
interface parameters are saved in this file. Saving in a file with the
“Interface”: None” setting is rejected with an error message. The
settings are activated for the actual interface if a file name is not
displayed in the header line or if this file is assigned the actual
interface.
Refer to the Manage sub-item
The V.24 interface dialog box is accessed, if:
• A V.24 parameter file was selected in the “Services” main screen
and was acknowledged using the “Input” key.
• The “Interface” softkey was pressed in the “Services” main screen.
In this case, the parameters of the V.24 and PG interfaces are
available for processing as before. The interface parameters are
saved independently of the V.24 DIR directory.
Manage
“Display” softkey
The parameters of the selected V.24 parameter file are displayed in
the “V.24 interface” screen. The file name is displayed in the header
line of this dialog box.
“New...” softkey
After entering a file name (max. 10 characters) the actual V.24
parameters are written to a new file in the V24.DIR directory.
To Next Page
Loading...
