Siemens SINUMERIK 840Di sl - Page 409

8
01/2008 Diagnostics operating area
8.4 Service displays
8
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 8-409
Signals
The following signals of the selected connection (in this case, e.g.
NCU710) are displayed in this dialog box:
• CPU-CPU communication ID
• Logical base address
• Connection number
• Parameterized maximum permissible communication time
• Actual communication time
• Maximum communication time
• Error reaction
Error reactions that can be set:
[0] "Alarm 27350 + STOP D/E"
[1] "Alarm 27350"
[2] "Alarm 27351 (self-clearing)"
[3] "No response from the system"
• Errors
• Diagnostics error code
• Replacement values active
• Actual communication data
• Driver state
Status code:
[0] "Not initialized"
[1] "Establish communication after booting"
[2] "Establish communication after error"
[3] "Wait for SN=1"
[4] "Wait for user acknowledgement"
[5] "Normal operation"
• Request user acknowledgement
• Sender in the deactivated safety mode