2
Operator Components/Operating Sequences 01/2008
2.5 General operating sequences
2
©Siemens AG 2008 All rights reserved.
2-60 SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Settings
Settings
Define the following values in the "Editor Settings" window:
• Horizontal scrolling ON/OFF
• Display hidden lines ON/OFF
• Deactivate LF in program
If this setting is selected, a space is displayed in the editor window
on the screen in place of the linefeed character. In the file to be
edited, the linefeed character is retained.
• Time interval for Automatic Save
When you set Automatic Save, you can also set the time intervals
at which text must be saved automatically (applicable only to files
on hard disk). If a value ≠ 0 is entered, the "Save file" softkey is not
displayed. If the value 0 is entered, automatic save is not
performed.
• Automatic numbering ON/OFF
A new block number is automatically inserted on every new line. If
you wish to assign new block numbers to an existing program, use
the "Renumber" function.
• Number of first block
• Incrementation of block numbers (e.g. 1, 5, 10)
Setting
contour
The following settings are possible for contour programming:
• Last line
Each time you complete a program step in the contour
programming you can insert a text in the last line
(e.g., "End of contour").
Additional information
• The coordinate system and the technology to be used are set via
the machine data; see Commissioning Manual HMI Advanced.
• Edited programs are automatically enabled after saving.
To Next Page
Loading...
