4
01/2008 Machine operating area
4.1 CNC data structure
4
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition 4-93
Additional information
The main screen of the selected mode appears on the screen.
If a mode change is not possible, please contact your installation
engineer, the machine-tool manufacturer or our service personnel.
In many cases, a mode change is enabled for trained personnel only
on safety grounds. To provide this type of protection, the control
system offers a facility for disabling or enabling mode changes.
Function Manual Basic Functions: Mode group, channel, program
operation, reset response (K1)
To Next Page
Loading...
