Siemens SITRANS TSinsert - Page 71

Maintenance and diagnostics SIMATIC PDM Device with display
(local operation)
Calibration Menu command "Maintenance > Calibra‐
tion"
One-point calibration input 1 [14]
(Page 88) /
One-point calibration input 2 [15]
(Page 88)
Display operating time Menu command "Diagnostics > Operat‐
ing time"
-
Display peak values
Reset peak values
"Diagnostics >
Peak values" parameter group
Minimum measured peak value at Input
1 [19] (Page 92) /
Maximum measured peak value at Input
1 [20] (Page 92) /
Minimum measured peak value at Input
2 [21] (Page 93) /
Maximum measured peak value at Input
2 [22] (Page 93)
HART communication SIMATIC PDM Device with display
(local operation)
Con󹪝gure HART address Menu command "Device >
Assign address and tag"
-
Select PV selector
Select SV selector
Select TV selector
Select QV selector
"Settings >
Assignment of dynamic variables" pa‐
rameter group
-
Write protection SIMATIC PDM Device with display
(local operation)
Enable and disable user PIN Menu command "Device >
Security"
Enable user PIN (Page 91) /
Disable user PIN (Page 91)
Change user PIN Menu command "Device > Security >
Change user PIN"
Change user PIN (Page 88)
PIN recovery - PIN recovery [17] (Page 89)
Enable and disable button lock - Enabling button lock (Page 94) /
Disabling button lock (Page 94)
Reset SIMATIC PDM Device with display
(local operation)
Device restart Menu command "Device > Device re‐
start"
-
Factory reset Menu command "Device > Reset >
Factory reset"
-
Reset to sensor calibration Menu command "Device > Reset >
Reset to sensor calibration"
-
Parameter assignment
8.1 Overview of parameters and functions
SITRANS TS100/TS200/TS300/TS500/TSinsert/TSthermowell
Operating Instructions, 08/2020, A5E47810090-AA 71